Oki MPS2731mc - Page 113

- 113 -
Printing from a Computer
5
Printing
5 Hold down the power switch for
approximately one second to turn on the
power.
Connecting using wireless LAN
(MC342dw, MC362w, MC562w, MC562dw,
ES5462dw MFP, MPS2731mc only):
Use the WPS (push button) function to set the
wireless LAN. For details on other methods
for setting the wireless LAN, refer to the
Conguration Guide.
1 Press the <SETTING> key on the operator
panel.
2 Press the to select [Wireless Setting],
and then press the
.
3 Log in by entering administrator password
of the device.
Use , , , key to select letter and then
press
OK
.
Default administrator password is “aaaaaa”.
The message below will be displayed for
about 5 seconds.
4 Check that [Automatic setup (WPS)]
is selected, and then press the .
5 Press the to select [WPS-PBC], and
then press
OK
.
6 Press the to select [Yes], and then
press
OK
.
Memo
● Start the WPS push button for wireless AP after clicking
[Yes] in the conrmation screen. Alternatively, if WPS
push button for wireless AP is started rst, start the
WPS push button on this equipment.
● If [No] is selected, the screen returns to that from
step 5.
7 If [Yes] is selected in step 6, [Running
pushbutton method...] is displayed in
the screen.
Note
● Panel operations cannot be performed during WPS
execution.
● When [WPS connection successful] is displayed,
this equipment is connected to the wireless LAN.