Oki OkiLAN 6120e - Chapter 3: HP Web Jetadmin Support; Chapter 3 HP Web Jetadmin Support; Overview; Configuring the Okilan 6120 E Using Web Jetadmin

II - 8
Section 2 - Chapter 3 - HP Web JetAdmin Support
OKI OkiLAN 6120e User’s Guide
Chapter 3
HP Web JetAdmin Support
Overview
This section contains instructions and information on
how to configure, install, and obtain diagnostic
information from your OkiLAN 6120e using the
Hewlett-Packard Web JetAdmin software.
Software Requirements
• Web JetAdmin 1.x, 2.x, 3.x, or 4.x
Note: For more information on installing and using
HP Web JetAdmin, refer to the HP Web
JetAdmin documentation.
Configuring the OkiLAN 6120e Using
Web JetAdmin
1. From the main Web JetAdmin page, select the
OkiLAN 6120e port you wish to configure.
2. On the Properties page, click the Config button.
3. Make any necessary changes to the options listed
and click the corresponding Apply button.
Installing a Windows NT Printer for
the OkiLAN 6120e
1. From the main Web JetAdmin page, select the
OkiLAN 6120e port you wish to install.
2. On the Properties page, click the Install Printer
button.
3. In the Specify the device address… field, enter the
print server IP address, followed by a comma and
then the output port number. For example, to install a
printer for output port 2 of an OkiLAN 6120e with
an IP address of 10.10.10.2, enter “10.10.10.2,2”.