III - 38
Section 3 - Chapter 4 - Using the OkiLAN 6120e in NDPS
OKI OkiLAN 6120e User’s Guide
Setting Up the OkiLAN 6120e in NetWare 5.1x
or Higher in TCP/IP
There is an accelerated procedure for setting up the OkiLAN 6120e
in NetWare 5.1x or higher in TCP/IP that is similar to the
procedure for NetWare 4.x and 5.x above. However, for this
procedure, OKI provides two snapins: an IP Address Configuration
Wizard and a dedicated NDPS Printer Control Snapin for the
OkiLAN 6120e.
Note: Before starting this procedure, you should add the OKI
printer driver using the NDPS broker. See Adding the OKI
Printer Driver Using the NDPS Broker above.
NDPS Printer Control Snapin
The OKI Printer Control Snapin may be used within the Novell
Generic Gateway, providing easy access to set up and configure
various OKI printer features.
To Next Page