Okuma OSP-U100M - Page 79

4203-E
P-59
SECTION
3
MANUAL
OPERATION
FUNCTIONS
(4)
Returning
a
tool
to
the
magazine
When
returning
a
tool
to
the
magazine
pot,
there
are
two
methods
such
as
(a)
specifying
the
toolpot
number;
and
(b)
returning
the
tool
to
an
empty
pot
automatically.
These
two
methods
are
detailed
below.
For
the
procedure
to
set
a
tool
on
the
spindle
manually,
refer
to
the
section
covering
the
manual
tool
change
procedure.
(a)
Tool
return
cycle
with
pot
number
specified:
1
)
Position
the
cursor
on
the
SPCY
POT
data
location.
Key
in
the
return
pot
number
and
press
the
WRITE
key.
2)
Set
a
tool
in
the
spindle.
3)
Position
the
cursor
on
the
ACT
TOOL
data
location.
After
keying
in
the
active
tool
number,
press
the
WRITE
key.
In
this
case,
the data
of
NXT
TOOL
should
be
NA.
If
a
tool
number has
been
entered,
key
in
after
locating
the
cursor
on
NXT
TOOL,
to
clear the
data.
4)
Press
the
1
CYCLE START
key.
The
tool
in
the
spindle
is returned
to
the
specified
pot
and
the
correspondence
between the
toolpot
number
and the
tool
number
is
set
and
stored.
If
this
operation
is intended
for
the
pot
which
is
assigned
with
another tool
number,
an error
occurs
and
tool
return
cycle
is
not
started.
(b)
Tool
return
cycle
without
pot
number
specified:
1
)
Clear
the
data
of
the
SPCY
POT
by
entering
as
asterisk
(*).
2)
Set
a
tool
in
the
spindle.
3)
Enter
the
active tool
nu
mber
for
ACT
TOOL
In
this
data
entry,
the
NXT
TOOL
data
must
be
NA.
4)
Press
the
1
CYCLE
START
key.
The
empty
pot
located
nearest
to
the
presently
indexed
pot
is
automatically
selected and
the
tool
return
cycle
is
started.
[Supplement]
1
.
Pressing
the
1
CYCLE
START
key
with
the
next
tool
number
specified,
initiates
the
normal
tool
change
cycle.
2.
The
SPCY
POT
data is
automatically
cleared
after
the execution
of
“1
cycle
start”
command.
3.
TheSPCYPOT
data
is
only
for
tool
return
cycle.
Therefore,
if
this dataand
the
NXT
TOOL
data
have
both
been entered
when
the
1
CYCLE
START
key
is
pressed,
an
error
occurs.
4.
In
the
automatic
empty
pot
selection,
the
empty
pot
is
looked
for
in
the
magazine
clockwise
direction rotation.
If
there
is
no
empty
pot,
an
error
occurs
and
no
return
cycle
is
carried
out.
5.
When
entering
a
large-diameter
tool,
enter
“,L”
following
the
tool
number.