Need help?Do you have a question about the Oldham OLC 100 and is the answer not in the manual?
General| Brand | Oldham |
|---|---|
| Model | OLC 100 |
| Category | Gas Detectors |
| Language | English |
Defines the intended use of the sensors for detecting specific gases.
Explains how the sensor converts gas into electrical signals.
Lists and illustrates detector components and internal elements.
Describes the company and side labels on the detector enclosure.
Compares the detection capabilities of OLC and OLCT 100 series detectors.
Outlines regulations for installations in explosive atmospheres.
Lists the required items for installation procedures.
Details power requirements for different detector types.
Guides on optimal placement and orientation for detectors.
Covers connection, preparation, entry, and wiring of detector cables.
Procedures for grounding enclosure and securely closing the detector cover.
Lists items and outlines pre-calibration checks and power-up procedures.
Specifies waiting times for sensor stabilization before adjustment.
Step-by-step guide for calibrating the OLC 100 model.
Details procedures for adjusting gas sensitivity for OLCT 100.
Step-by-step guide for calibrating the OLCT 100 model.
Lists calibration coefficients for various explosive gases and sensor types.
Discusses how often maintenance and testing should be performed.
Lists specific periodic maintenance tasks.
Explains how to open the detector enclosure for maintenance.
Details how to check and match the transmitter and controller.
Summarizes common faults and their causes for OLC/OLCT 100.
Step-by-step guide for replacing the sensor block.
Specific instructions for replacing sensors in high-temperature models.
Tools and kits for calibration and sensor maintenance.
Accessories for sampling and splash protection.
Accessories for mounting and specialized measurements.
Accessories for environmental protection, mounting, and detector replacement.
Lists different cable glands, their purpose, and references.
Comprehensive list of replacement sensors and boards for the detectors.
States that the following pages reproduce the EU declaration of conformity.
Details ATEX, EMC, and functional safety certifications.
Details compliance with Marine Equipment Directive and applicable standards.
Provides diagrams and measurements of detector dimensions.
Lists general technical parameters like voltage, consumption, cable types, and approvals.
Detailed characteristics for various sensor types, including gas-specific data.
States detector compliance with ATEX and IEC standards for explosive atmospheres.
Requirements for cables, joints, static hazards, and performance in explosive zones.
Discusses transfer curves, limitations, component interference, and low oxygen effects.
Detector certification for SIL, safety functions, and reliability data.
Mandatory tests and conditions for specific usage scenarios.
Lists all gases detectable by the OLC/OLCT 100, including codes and ranges.
Explains how to construct part numbers for ordering detectors.
Provides plant and office contact details for Americas, Asia Pacific, and Europe.
To Next Page
