NOTICE:
Too
much or too little fluid can damage your
transaxle.
Too
much can mean that some of the
fluid could come
out
and fall on hot engine parts
or exhaust system parts, starting a fire. Be sure to
get an accurate reading if
you
check your
transaxle fluid.
Wait at least
30
minutes before, checking the transaxle
fluid level
if
you have been driving:
When outside temperatures
are
above 90°F (32°C).
0
At high speed for quite a while.
In
heavy traffic
--
especially in hot weather.
a
'
While pulling a trailer.
To
get the right reading; the fluid should be at normal
operating temperature, which is 180°F to 200°F (82°C
to 93°C).
Get the vehicle warmed up by driving about 15 miles
(24
km)
when outside temperatures are above
50°F
(10°C).
If it's colder than
50°F
(lO"C),
you may have
to drive longer.
To
check the fluid level
0
0
0
0
Park
your vehicle on a level place. Keep the engine
running.
With the parking brake applied,.place the shift lever
in PARK
(P).
J
With your foot on the brake pedal, move the shift
lever through each gear range, pausing for about
three seconds in each range. Then, position the shik:
lever in
PAkK
(P).
Let the engine-run at idle for three to five minutes.
6-17
To Next Page
Loading...
