3.1L L82 (Code
M)
Engine
3.4L
LQ1
(Code
X)
Engine
3.
Check both'sides
of
the dipstick, and read the lower
level. The fluid level must be:in the cross-hatched
area.
1.
The transaxle fluid dipstick handle is the red loop
4.
If
the fluid level is in the acceptable range, push the
near the back
of
the engine. Pull out the dipstick and dipstick back in all the way.
'wipe it with a clean rag or paper towel.
then pull it back out again.
2. Push it back
in
all the yay, wait three seconds and
To Next Page
Loading...
