Elapsed Time (ET)
When the ignition is on, the DIC can be used as a
stopwatch. The display will show hours and minutes.
The elapsed time indicator will record up to
100
hours,
then it will reset to zero and continue counting. Press
ET, and the display will show the amount
of
time that
has elapsed since the elapsed time indicator was last
reset (not including time
the
ignition is off), such
as:
01:08
ELAPSED TIME
To
reset elapsed time to zero, press RESET while the
elapsed time is displayed.
Date
Press DATE to display the date. To change the date,
press DATE then RESET. The following display
will appear:
MONTH?
XX/DD/YY
MM, DD and YY represent
the
month, date and year
you currently have in your system. Check to make sure
your clock is in the correct AM or PM mode.
Notice that each key has a number. Push the key to enter
the number. The first XX’s will flash until you enter the
first digit for the month. You don’t need to enter the
leading zero if the number is under
10.
Press ENTER
after you’ve entered the month. The display will
change to:
DAY? MM/XX/YY
Set the day just as you set the month. After the day entry
is
made, press ENTER and the display will change to:
YEAR? MM/DD/XX
Set the year just as you set the month and day.
If
a valid
date is entered, the display will automatically exit to the
date mode and display the day of the week, the month
and the date. If an invalid date is entered, the display
will return to MONTH? XX/DD/YY and you’ll need
to
repeat the above steps.
After
a
battery reconnect
(loss
of power),
the
display
will read CONFIRM TIME AND DATE.
2-85
To Next Page
Loading...
Need help?
General
