RCL:
Press this button briefly to recall
the
station being
played or to display the clock.
To
change what is
normally shown on the display (station or time), press
the
RCL
button until you
see
the display you want, then
hold the RCL button until the display flashes. If you
press the button when the ignition is off,
the
clock will
show for a few seconds.
Finding
a
Station
AM-FM:
Press this button to switch between AM,
FMl
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly so
it
extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow to
go
to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release
it
to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then
go
on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and SCAN will appear on the
display. If you press SCAN for more than two seconds,
the radio will change to P SCAN mode. P SCAN will
appear on the display.
PUSHBUTTONS:
The five numbered pushbuttons let
you return
to
your favorite stations. You can set up
to
15
stations (five AM, five
FM
1
and five
FM2).
Just:
1.
2.
3.
4.
5.
6.
Turn the radio on.
Press AM-FM to select the band.
Tune in the desired station.
Press
TONE
to select the equalization that best suits
the type
of
station selected.
Press and hold one of the five numbered buttons.
The sound will mute, When
it
returns, release the
button. Whenever you press that numbered button,
the station you set will return and the tone that you
selected
will
also
be
automatically selected for
that button.
Repeat the steps for each pushbutton.
P
SCAN:
Press SCAN for more than two seconds, and
P
SCAN will appear on the display. The radio will
go
to
the first preset station stored on your pushbuttons, stop
for a few seconds, then
go
on to the next preset station.
Press SCAN again to stop scanning.
3-12
To Next Page
Loading...
Need help?
General
