Your tape bias is
set
automatically. When a metal or
chrome tape is inserted, HI-BIAS appears on the
display.
If
you want to insert a tape when the ignition is
off, first press
EJECT
or RCL.
If
E
and a number appear on the radio display and the
tape won’t play because of an error, it could be that:
ElO:
The tape is tight and the player can’t turn the
tape hubs. Remove the tape. Hold the tape with the
open end down and try to turn the right hub
counterclockwise with a pencil. Turn the tape over
and repeat. If the hubs do not turn easily, your tape
may be damaged and should not be used in
the
player. Try a new tape to make sure your player is
working properly.
Ell:
The tape is broken. Try a new tape.
If any error occurs repeatedly or
if
an error can’t be
corrected, please contact your retailer. If your radio
displays an error number, write it down and provide it to
your retailer when reporting the problem.
REV
(1):
Press this button to reverse the tape rapidly.
Press
it
again to return to playing speed. The radio will
play the last-selected station while the tape reverses.
You may select stations during
REV
operation by
using
TUNE.
FWD
(2):
Press this button to advance quickly to
another part of the tape. Press the button again
to
return
to
playing speed. The radio will play the last-selected
station while the tape advances.
You
may select stations
during
FWD
operation by using TUNE.
PROG
(3):
Press this button to play the other side of
the tape.
00
(4):
Press this button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks
of
Dolby Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing a
cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search for the
next
or
previous selection on the tape. Your tape must
have at least three seconds
of
silence between each
selection for
SEEK
to
work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again
to
stop scanning. The sound will mute
3-14
I
To Next Page
Loading...
Need help?
General
