Oldsmobile 1997 Aurora

If you find that the headlamp aiming needs adjustment,
follow these steps:
Start with the vertical headlamp aim. Don't try
to adjust
the horizontal aim first. Adjustment screws can be
turned with an
E8 Torx@socket or T15 Torx screwdriver.
1. Check the vertical aim for each headlamp. The
vehicle must be on a level surface.
Turn the vertical
aiming screw until the bubble in
the level is centered
at
0 (zero).
2. Now adjust the horizontal aim. Check the horizontal
aim for each headlamp and adjust it as necessary.
Turn the horizontal aiming screw until the pointer is
lined up with the
0 (zero).
3. Now, visually re-check the vertical aim, to make
sure it is still correct after the horizontal aim
adjustment. Readjust,
if necessary.
6-38