1.
Buckle the center passenger position safety belt, and
then route the safety belts through the proper
slots
in
the seat cushion. Don’t let the safety belt get twisted.
2.
Slide the rear
of
the cushion up and under the
seatback
so
the rear locating guides hook into the
wire loops
on
the back frame.
3.
With the seat cushion lowered, push rearward and
then press down on the seat cushion until the spring
locks on both ends engage.
4.
Check to make sure the safety belts are properly
routed and that no portion
of
any safety belt is
trapped under the seat.
Also
make sure the seat
cushion
is
secured.
Rear Compartment
Fuse
Blocks
V“
7-
?
d
Once the seat is removed,
you’ll find two fuse panels
on the driver’s side
of
the
battery. Each is protected by
a plastic box with four tabs.
Pull
up
on all four tabs at
the same time to loosen
them and pull off the box.
Of these two panels, the cover on the passenger’s side
fuse
panel has an extra plastic cap attachment. You’ll
need to slide this out of the grooves which hold it there
before removing the rest
of
the
box.
To
replace
the
covers, line the four tabs up and simply
snap them back into place. The extra plastic cap
attachment slides back into place.
6-67
To Next Page
Loading...
Need help?
General
