Customizing
Your
Automatic Door
Locks
Feature
You can program the automatic door locks feature
to
change
to
the
following modes:
Mode
Operation
0
No
automatic door lock or unlock.
1
2
3
All doors automatically lock when
shifted out of PARK (P).
No
automatic
door unlock.
All doors automatically lock when shifted
out
of
PARK (P). Only the driver’s door
automatically unlocks when shifted into
PARK
(P).
All doors automatically lock when shifted
out
of
PARK (P). All doors automatically
unlock when shifted into PARK
(P).
Vehicles are delivered programmed
in
Mode
3.
To
change modes:
1.
Close all doors and turn the ignition on. Keep all
2.
Press and hold the driver’s power door lock switch
doors closed throughout this procedure.
through Step
4.
3.
Press the LOCK button on the Remote Lock Control
transmitter. The automatic door locks will remain in
the current mode.
4.
Press the LOCK button on the transmitter again.
Each time the transmitter’s LOCK button is pressed,
the mode will advance by one, going from Mode
3
to
0
to
1,
etc.
NOTE: The door locks will cycle according to the
mode entered while customizing memory door locks.
(Mode
“0”
has
no feedback.)
5.
Release the power
door
lock switch. The automatic door
locks will remain
in
the most recent mode selected.
6.
Turn the ignition to
OFF,
2-6
To Next Page
Loading...
Need help?
General
