RCL:
Press
this
button briefly to recall the station being
played or to display the clock. To change what
is
normally shown on the display (station or time), press
the RCL button until you see the display you want, then
hold the RCL button until the display flashes. If you
press the button when the ignition is
off,
the clock will
show for a few seconds.
Finding
a
Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down
arrow
to
go
to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release it to listen to
stations-for a few seconds. The radio
will
go
to
a station,
stop for a few seconds, then go on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and SCAN will appear on the
display.
If
you press SCAN for more than two seconds,
the radio will change to P SCAN mode. P SCAN will
appear on the display.
PUSHBUTTONS:
The five numbered pushbuttons let
you return to your favorite stations. You can set up to
15
stations (five
AM,
five
FM1
and
five
FM2).
Just:
1.
Turn
the radio on.
2.
Press AM-FM to select the band.
3.
Tune in the desired station.
4.
Press TONE
to
select the equalization that best suits
the type of station selected.
5.
Press and hold one of the five numbered buttons.
The sound will mute. When it returns, release the
button. Whenever you press that numbered button,
the station you set will return and the tone that you
selected will also be automatically selected for
that button.
6.
Repeat the steps for each pushbutton.
P
SCAN:
Press SCAN for more than two seconds, and
P SCAN will appear on the display. The radio will go to
the first preset station stored on your pushbuttons, stop
for a
few
seconds, then
go
on to the next preset station.
Press SCAN again to stop scanning.
3-10
To Next Page
Loading...
