AM-FM
Stereo
Playing
the
Radio
PWR-VOL:
Press this knob to
turn
the system on and
off.
To
increase volume, turn the knob to the right. Turn
it
to the left to decrease volume.
RECALL:
Press this button briefly to recall the station
being played or to display the clock.
To
change what is
normally shown on the display (station
or
time), press
the
RECALL
button until you see the display you want,
then hold the
RECALL
button until the display flashes.
If
you press the button when the ignition is
off,
the clock
will show for a few seconds.
Finding
a
Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow to go to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release
it
to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then go on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and
SCAN
will appear on the
display. If you press
SCAN
for more than two seconds,
the radio will change to P
SCAN
mode. P
SCAN
will
appear on the display.
3-7
To Next Page
Loading...
