Windshield Wipers
You control the windshield wipers by moving the stalk
with the wiper symbol
on
it up or down.
For a single wiper cycle, push the stalk down to
MIST,
then release it. For more cycles, hold the stalk
down longer.
For steady wiping at low speed, move the stalk up to the
LO
position. For high-speed wiping, move the
stalk
up
hrther, to
HI.
To
stop the wipers, move the stalk to
OFF.
You can set the wiper speed
for
a long or
short
delay between
wipes.
This
can be very useful
in
light rain or
snow.
2-31
To Next Page
Loading...
