Reprogramming a Single HomeLink@
Button
To
program a device
to
HomeLink@ using a HomeLink@
button previously trained, follow these steps:
1.
Press and hold the desired HomeLink@ button.
Do
2.
The indicator light will begin to flash after
not release the button.
20
seconds. While still holding the HomeLinkO
button, proceed with Step
2
under “Programming
HomeLinka
.”
Resetting Defaults
To reset HomeLink@ to default settings
do
the following:
1.
Hold down the two outside buttons for about
20
seconds until the indicator light begins
to
flash.
2.
Continue to hold both buttons until the HomeLink@
indicator light turns
off.
3. Release both buttons.
For
questions or comments, contact HomeLink@ at
1-800-355-3515, or on the internet at
www.homelink.com.
2-40
To Next Page
Loading...
