Programmable Automatic Door
Locks
Your vehicle is equipped with an automatic IocWunlock
feature which enables you
to
program your vehicle’s
power door locks. You can program this feature through
the Driver Information Center (DIC), or by the following
method.
Programmable Locking Feature
The following is the list of available programming
options:
Mode
1:
All
doors lock when the transmission is shifted
into gear.
Mode
2:
All
doors lock when the vehicle speed is
greater than
8
mph
(13
km/h).
Mode
3:
No
automatic door locking.
The automatic door locks were pre-programmed at the
factory to lock all the doors when the transmission
is shifted into gear. The following instructions detail how
to
program your door locks differently than the factory
setting. Choose one of the three programming
options listed above before entering the program mode.
To enter the program mode you need to do the
following:
1.
2.
3.
Begin with the ignition
off.
Then pull the turn
signaVmultifunction lever toward you and hold
it there while you perform the next step.
Turn the key
to
RUN
and LOCK twice. Then, with the
key in LOCK, release the turn signaVmultifunction
lever. Once you do this, you will hear the lock switch
lock and unlock, the horn will chirp twice, and a
30
second program timer will begin.
You are now ready to program the automatic door
locks. Select one of the three programming options
listed above, and press the lock side of the power
door lock switch to cycle through the lock options.
You will have
30
seconds
to
begin programming. If
you exceed the
30
second limit, the locks will
automatically lock and unlock and the horn will chirp
twice
to
indicate that you have left the program
mode. If this occurs, repeat the procedure beginning
with Step
1 to
re-enter the programming mode.
You can exit the program mode any time by turning the
ignition
to
RUN.
The locks will automatically lock and
unlock and the horn will chirp twice
to
indicate that you
are leaving the program mode. If the IocWunlock switches
are not pressed while in the programming mode, the
current auto IocWunlock setting will not be modified.
See your dealer for more information.
2-1
0
To Next Page
Loading...
