To turn the system on or
off,
press the TAS OFF/ON
button located near the
shift lever.
If
you used the
button to turn the system
off, the TRAC OFF light on
the button will come on
and stay on.
You
can turn the system back on at any time by
pressing the button again. The TRAC OFF light on the
button should go off.
If
desired, you can change the TAS automatic
engagement feature
so that the system will not come on
automatically when the engine is started. To do
so:
1.
Park the vehicle with the ignition off and the
2.
Turn the ignition to RUN; do not start the engine.
3.
Apply the brake pedal, press the accelerator
transmission in PARK (P).
pedal
to
the floor and then press the TAS OFF/ON
button and hold it down for at least six seconds.
4.
Release the TAS button and both pedals.
The next time you start your vehicle, the TAS will not
automatically come on. You can restore the automatic
feature by using the same procedure. Whether the TAS
is set
to
come on automatically or not, you can always
turn the system on or off by pressing the TAS on/off
button.
Locking Rear
Axle
If your vehicle has this feature, your locking rear axle
can give you additional traction on snow, mud, ice, sand
or gravel. It works like a standard axle most of the
time, but when one
of
the rear wheels has no traction
and the other does, this feature will allow the wheel with
traction to move the vehicle.
Steering
Power
Steering
If you lose power steering assist because the engine
stops or the system is not functioning, you can steer but
it will take much more effort.
5.
Turn off the ignition and wait a few seconds.
4-1
0
To Next Page
Loading...
