Adding Washer Fluid
Open the cap with the
washer symbol on it. Add
washer fluid until the
tank is full.
Notice:
e
0
0
e
When using concentrated washer fluid, follow
the manufacturer’s instructions
for
adding
water.
Don’t
mix
water with ready-to-use washer
fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts
of the washer system.
Also,
water doesn’t
clean
as
well as washer fluid.
Fill your washer fluid tank only three-quarters
full when it’s very cold. This allows for
expansion if freezing occurs, which could
damage the tank if
it
is completely full.
Don’t use engine coolant (antifreeze)
in
your
windshield washer.
It
can damage your
washer system and paint.
Brakes
Brake Fluid
L
A
L
L
1
Your brake master cylinder reservoir is filled with DOT-3
brake fluid. See
Engine Compartment Overview on
page
5-72
for the location of the reservoir.
There are only two reasons why the brake fluid level in
the reservoir might
go
down. The first
is
that the
brake fluid goes down to an acceptable level during
normal brake lining wear. When new linings are put in,
the fluid level goes back up. The other reason is
that fluid is leaking out of the brake system.
5-34