Finding a Station
BAND:
Press this button
to
switch between AM,
FMl
and FM2. The display will show your selection.
TUNE:
Turn this knob
to
select radio stations.
<
SEEK
>
:
Press the right or the left arrow
to
go to
the next or
to
the previous station and stay there.
The radio will seek only
to
stations
to
stations that are
in the selected band and only
to those with a strong
signal.
<
SCAN
>
:
Press and hold either arrow for two
seconds until SC appears on the display and you hear
a
beep. The radio will go to a station, play for a few
seconds, then go on
to
the next station. Press either
SCAN arrow again
to stop scanning.
To scan preset stations, press and hold either SCAN
arrow for more than four seconds. PRESET SCAN will
appear on the display. You will hear a double beep
and the P will blink with the preset number. The radio
will go
to the first preset station stored on your
pushbuttons, play for a few seconds, then go on
to
the
next preset station. Press either SCAN arrow again
to
stop scanning presets.
The radio will scan only
to
stations that are in the
selected band and only
to
those with a strong signal.
Setting Preset Stations
The six numbered pushbuttons let you return
to
your
favorite stations. You can set up
to
18
stations (six AM,
six FMI and six FM2), by performing the following steps:
1.
Turn the radio on.
2. Press BAND
to
select AM, FMI or FM2.
3.
Tune in the desired station.
4.
Press
AUTO
EQ
to
select the equalization that best
5. Press and hold one of the six numbered
suits the type of station selected.
pushbuttons until you hear a beep. Whenever you
press that numbered pushbutton, the station
you set will return and the equalization that you
selected will also be automatically selected for that
pushbutton.
6.
Repeat the steps for each pushbutton.
Setting the Tone (BasdTreble)
AUDIO:
Press and release the AUDIO button until
BASS, MID or
TREB
appears on the display. Press the
knob above the AUDIO button
to
extend it, then turn
the knob
to
increase or
to
decrease. If a station is weak
or noisy, you may want
to
decrease the treble.
Pressing and holding the AUDIO button for at least two
seconds will return all tone settings, including balance
and fade
to
flat.
3-58
To Next Page
Loading...
