k
SCAN
>I
:
Press and hold either SCAN arrow for
two seconds until SC appears on the display and
you hear a beep. The radio will go
to
a station, play for
a few seconds, then go on to the next station. Press
either SCAN arrow again to stop scanning.
To scan preset stations, press and hold either SCAN
arrow for more than four seconds. PRESET SCAN will
appear on the display. You will hear a double beep.
The radio will go
to a preset station stored on your
pushbuttons, play for a few seconds, then go on
to
the
next preset station. Press either SCAN arrow again
to stop scanning presets.
The radio will scan only
to
stations that are in the
selected band and only to those with a strong signal.
Setting Preset Stations
The six numbered pushbuttons let you return
to
your
favorite stations. You can set up
to
18
stations (six AM,
six FM1 and six FM2) by performing the following
steps:
1.
2.
3.
4.
5.
6.
Turn the radio on.
Press AM FM
to
select AM, FMI or FM2.
Tune in the desired station.
Press AUTO
EQ
to
select the equalization that best
suits the type of station selected.
Press and hold one of the six numbered
pushbuttons until you hear a beep. Whenever you
press that numbered pushbutton, the station
you set will return and the equalization that you
selected will also be automatically selected for that
pushbutton.
Repeat the steps for each pushbutton.
3-67