How
to Reset the
CHANGE
ENG
OIL
Light
The GM Oil Life System calculates when to change
your engine oil and filter based on vehicle use. Anytime
your oil is changed, reset the system
so
it can
calculate when the next oil change is required. If a
situation occurs where you change your oil prior to a
CHANGE ENG OIL light being turned on, reset the
system.
To
reset the CHANGE ENG OIL light, do the following:
1.
Turn the ignition key to RUN with the
2.
Fully press and release the accelerator pedal three
engine
off.
times within five seconds.
For vehicles with the Driver Information Center, see
Driver
Information Center (DE) on page
3-43
to reset
the system.
What
to
Do
with
Used
Oil
Used engine oil contains certain elements that may be
unhealthy for your skin and could even cause cancer.
Don’t let used oil stay on your skin for very long. Clean
your skin and nails with soap and water, or a good
hand cleaner. Wash or properly dispose of clothing or
rags containing used engine oil. See the manufacturer’s
warnings about the use and disposal of oil products.
Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil from the
filter before disposal. Never dispose
of
oil by putting it
in
the trash, pouring it on the ground, into sewers, or into
streams
or
bodies of water. Instead, recycle it by
taking it to a place that collects used oil. If you have a
problem properly disposing
of
your used oil, ask
your dealer, a service station or a local recycling center
for help.
Engine
Air
CleanedFilter
The engine air cleanedfilter
is located toward the front
of the engine compartment
on the passenger’s side
of the vehicle.
See
Engine Compartment
Overview
on page
5-12
for
more information on engine air cleaner filter location.
5-1
8
To Next Page
Loading...
