Parking Brake and Automatic
Transmission Park (P) Mechanism
Check
I
When you are doing this check, ur hicle
could begin to move. You or others could be
injured and property could be damaged. Make
sure there is room
in
front of your vehicle
in
case it begins to roll. Be ready to apply the
regular brake
at
once should the vehicle begin
to move.
To check the parking brake’s holding ability: With
the engine running and transmission in NEUTRAL
(N), slowly remove foot pressure from the regular
brake pedal.
Do this until the vehicle is held by the
parking brake only.
To check the PARK
(P)
mechanism’s holding
ability: With the engine running, shift to PARK
(P).
Then release the parking brake followed by the
regular brake.
Underbody Flushing Service
At least every spring, use plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud and other debris
can collect.
Park on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot on the regular brake, set the
parking brake.
6-1
4
To Next Page
Loading...
