c
1
A
2. Remove the Tom@
screws at the eqd of the
aiming ring. The aiming
ring will swing open like
a gate.
3.
Remove the aiming ring.
4.
Lift the plastic locking
tabs on the electrikal
connector and pull the
connector from the
headlamp socket.
Note which way the socket is pointing before you
disconnect it. You'll need to install the new headlamp
so
the socket points in the same direction.
5.
Remove the headlamp.
6.
Check that the number on the new headlamp
matches the number on the headlamp being replaced.
The letter on the headlamp
(U
or L) must also match.
To Next Page
Loading...
