7.
Plug the electrical connector into the headlamp socket.
Headlamps
(4-Door
Models)
Make sure the locking: tabs snap onto the socket.
v
L
8.
Put the new headlamp in position.
0
Make sure the socket points in the same direction
as it did with the old headlamp.
9.
Insert the tabs on the
aiming ring into
the slots in the
headlamp assembly.
WI
1.
Turn the socket counterclockwise one-sixth
of
a turn
until the tabs on the bulb socket align with the slots
in the housing.
10.
Holding the aiming ring closed, insert
the
screws at the
2.
pull
out
the
bulb
socket.
end
of
the ring. Tighten the screws until the aiming ring
touches the plastic nuts on both the top and bottom.
0
Do
not overtighten.
Do
not damage the vertical aiming bubble.
6-32
I
To Next Page
Loading...
