EasyManua.ls Logo

Olimpia splendid piu - Troubleshooting Common Issues; Problem Diagnosis and Solutions

Olimpia splendid piu
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EPNL
53
GR
TROUBLE SHOOTING
PROBLEMS
The conditioner does not work.
The conditioner works only for a
short period.
The conditioner works but does not
refresh the room.
Water leaks from the conditioner
during transport.
Alarm signal " Fi " appears on the control
panel display
The conditioner switches off, the controls on
the remote control and the control panel do
not respond and alarm signal "2" flashes on
the control panel display.
The conditioner switches off, the controls on
the remote control and the control panel do
not respond and alarm signal "8" flashes on
the control panel display.
The conditioner switches off, the controls on
the remote control and the control panel do
not respond and alarm signal "3" flashes on
the control panel display.
Alarm signal "13" flashes on the control
panel display.
SUGGESTED SOLUTION
Wait.
Plug in the conditioner.
Switch off the timer
Lower the temperature set.
Remove the obstructions.
Call the Service Center.
Close the window.
Eliminate sources of heat.
Lower the temperature set.
Remove the plug (fig.2 ref. n°4) and drain
the water before moving the conditioner.
Clean the filter (refer to section 3.17)
Switch the appliance back on and press
button SW1 on the control panel for 5
seconds so that the alarm signal disappears
from the display.
Call the Service Centre.
Call the Service Centre.
Dain the water contained by removing the
plug (fig.2 ref. n°4). If this alarm is displayed
too frequently, call the Service Centre.
Call the Service Centre.
LIKELY CAUSE
No power.
The plug has not been inserted.
Timer is ON
The temperature set is too close to
ambient temperature.
Suction of outside air is obstructed.
Window open.
Some source of heat is operating in the
room (burner, lamps, etc.) or the room
is crowded.
The temperature set is too high.
The power of the conditioner is not
suitable for ambient conditions or
dimensions.
The conditioner has been tilted or laid
flat.
The filter is dirty
Excessive build-up of water inside the
conditioner
GB

Table of Contents

Related product manuals