0723S20008
TROUBLE SHOOTING
NEVER ATTEMPT TO CLEAN OR SERVICE THIS MACHINE UNTIL
IT HAS BEEN DISCONNECTED FROM THE POWER SUPPLY AND
YOU ARE SURE THE BLADE HAS STOPPED.
THE SLICER MOTOR WILL NOT START OR WAS RUNNING BUT SUDDENLY
STOPPED.
• Check to see if the machine's plug was accidentally removed.
• If plugged in, is the outlet working? Test it with another, working, small appliance.
• Your slicer’s motor is equipped with a thermal overload. Should the motor become
overheated it will stop. (See “Resetting the Thermal Overload” below)
• If you still can not find the problem have a qualified electrician check the unit's motor
and switch.
RESETTING THE THERMAL OVERLOAD
• To restart the machine allow the motor to cool for approximately one to two hours.
Then carefully tip the machine to one side so that you can press the red reset button
which is located on the end of the motor. Press the button FIRMLY
. Return the
machine it’s proper position, connect it to the power supply and attempt to restart the
machine.
ATTEMPTING TO START THE MACHINE AFTER
PRODUCT HAS BEEN
INSERTED IN THE MACHINE OR ATTEMPTING TO CUT PRODUCT
WITH A DIRTY BLADE MAY CAUSE OVERLOADS.
To Next Page
Loading...
