Need help?Do you have a question about the Oliver 797-32NC and is the answer not in the manual?
General| Brand | Oliver |
|---|---|
| Model | 797-32NC |
| Category | Kitchen Appliances |
| Language | English |
Overview of the Oliver Model 797-N series bread slicers and their features.
Technical specifications including space requirements, capacities, and electrical options.
Step-by-step guide for safely removing the slicer from its shipping skid.
Instructions for installing optional casters and securing the slicer.
How to adjust the holddown for optimal slicing performance and product clearance.
Guide for adjusting infeed chute side guides for product length.
Instructions for aligning outfeed guides to prevent end slices from falling.
Basic steps for loading and operating the gravity feed slicer.
How to use the last loaf pusher to feed the final product through the slicer.
Steps to diagnose and resolve issues when the motor does not start or hum.
Steps to diagnose and resolve issues when the motor hums but doesn't run.
Solutions for inconsistent slice thickness due to blade frame adjustment.
Troubleshooting guide for knocking sounds from the blade frames.
Causes and solutions for excessive vibration during slicer operation.
How to fix issues causing slow cutting or damage to the bread.
Procedures for cleaning the exterior surfaces and crumb tray of the slicer.
Guidelines for lubricating pivot points and bearings on the slicer.
Detailed steps for safely removing the blade frames from the slicer.
Step-by-step instructions for replacing the cutting blades.
Guide for adjusting the tension of the drive belt on the slicer.
Procedure for removing and installing a new drive belt.
How to adjust blade frames for consistent slice thickness.
Method for aligning blade frames to ensure proper cutting clearance.
List of part numbers for the main frame and rocker assembly.
List of part numbers for the base and caster assembly.
List of part numbers for the slice and holddown components.
List of part numbers for the 32-inch gravity infeed chute assembly.
List of part numbers for the 48-inch gravity infeed chute assembly.
List of part numbers for the 32-inch combination infeed chute.
List of part numbers for the standard outfeed assembly.
List of part numbers for the driven pulley assembly.
Electrical wiring diagram for single-phase slicer configurations.
Lists of parts for various single-phase electrical setups.
Electrical wiring diagram for three-phase slicer configurations.
Lists of parts for various three-phase electrical setups.
To Next Page
