797-N BREAD SLICER
0797S20023 3-2
CASTER INSTALLATION INSTRUCTIONS
Place blocks on the floor approximately (8) and (38) inches from the discharge side of
the slicer, see the illustration below. Lower the hold-down to its lowest position and
tighten the adjustment knob to prevent the outfeed table from swinging out. With one
person on each side of the slicer, gently lower the slicer onto the blocks.
CAUTION
NEVER ATTEMPT TO LIFT THE SLICER BY ITS INFEED CHUTE
AS DAMAGE TO THE MACHINE MAY RESULT.
Locate the casters, ¼-inch bolts, lock washers, and nuts in the option package. Install
the casters using the furnished hardware as shown in the figure on the next page tighten
the bolts and nuts securely using two wrenches. Install both locking casters on the
discharge side of the machine. See the next illustration. Set the brakes tightly on both
locking casters, (this will help to keep the wheels from rolling when lifting the slicer back
to its upright position).
Install the two rigid casters in the same manner on the infeed side of the slicer.
Rev. 8/3/04
To Next Page
Loading...
Need help?
General
