797-N BREAD SLICER
0797S20026 6-3
Removing the Blade Frames (Continued)
NOTE
NEVER LOOSEN THE NUTS ON THE ECCENTRIC PINS OR ATTEMPT
TO REMOVE THEM TO AID IN REMOVING THE BLADE FRAMES.
Start by pulling the hairpin clip from the eccentric pin, located at the top of each blade
frame, see illustration below, then slide the top link toward the eccentric pin’s mounting
plate. Make sure that the link is forced all the way over to the plate.
After removing the two locking cams, eyebolts and Belleville washers, (which secure the
blade frame to the rocker’s swing shaft), the blade frame can be removed. The eyebolts
and Belleville washers can be removed by turning them counter clockwise once the
cams have been removed. See illustration below.
To Next Page
