olympia electronics BS-116 - History Record Deletion; Automatic Unit Recognition; Setting the User Code

ENABLE
SIREN 1
With the numeric keypad and the ‘ENTER’ key select the required SIREN
output. The Display shows:
And the siren output is activated.
SIREN OUTPUT 1
IS ENABLED
ENABLE
RELAYS OF UNIT 1
With the numeric keypad and the ‘ENTER’ key select the required BS-117
device. The Display shows:
If ‘ENTER’ is pressed then all the relays of the BS-117 are activated.
1234567890123456
ENABLE
RELAY (1/64) 01
With the numeric keypad and the ‘ENTER’ key select a specific relay (e.g
relay1) of the selected BS-117 device. The Display shows:
If ‘ENTER’ is pressed again then the chosen relay is activated.
1234567890123456
7.6 History record deletion
The sixth selection of the technicians menu is
If ‘ENTER’ is pressed then the history record of the system is deleted. All ALARM and
FAULT events are written in this record.
DELETE
HISTORY FILE
7.7 Automatic unit recognition
The seventh selection in the technicians menu is
If ‘ENTER’ is pressed the SETUP procedure described in section 5 commences.
AUTOMATIC
UNIT DETECTION
7.8 Setting the user code.
The eight selection in the technicians menu is
If we press ‘ENTER’ the display shows :
Using the numeric keypad enter the required 4-digit code that will be used as a user
access code. The default user code set is “0000”.
SET
USER CODE
ENTER YOUR CODE
0000
20 from 21
921116000
Date
File
Code
Page
921116000_09_016
13/03/2013