0
1
2
3
4
0
1
2
3
4
5
Page 8 from 18
If we want to change the keyboard address we must type in the required number (1
to 4 according to the address selection table shown below) and at the end press the
ENTER key for the new value to be accepted.
At the end of the process press successively the ESC key to exit programming
mode.
ADDRESS PROGRAMMING
No communication (keyboard deactivated)
(Default) the keyboard operates as master (U1)
The keyboard operates as repeater keyboard (U2)
The keyboard operates as repeater keyboard (U3)
The keyboard operates as repeater keyboard (U4)
6.2.2 CLr?. Signal/Call resetting.
This programming operation changes the way that the user can reset the
signals/calls accepted by the system.
Insert the technical code (1111) and using the FAULT EVENTS key scroll to the
menu item S-UP and press ENTER. The indication Clr? Is shown on the display.
Press the ENTER key and the indication _ _ _ 1 is shown. (This means that this
keyboard has a value of 1) Depending on this value the calls are reset/cancelled as
shown in the table below .
If we want to change the value, press the required number (0 to 5) and then press
ENTER so the keyboard can store this new value.
At the end of the process press successively the ESC key to exit programming
mode.
VALUE
PROGRAMMING
The BUZZER ON-OFF HELP key has no affect
(default) The BUZZER ON-OFF HELP key resets only one signal
while the code 0000 resets all the signals.
The only one signal
while the code 0000 has no affect
BUZZER ON-OFF HELP key resets
The code 0000 resets only one signal while the
BUZZER ON-OFF HELP key has no affect
The all the signalsBUZZER ON-OFF HELP key resets
The code 0000 resets all the signals
921746000_09_003
To Next Page
Loading...
