Page 7 from 18
5. ACCESS CODES
User code (0000). Using this code we can reset all calls accepted by the panel. The
default value is (0000)
Technical code (1111). Using this code we can access the programming menu. The
default value is (1111)
Reset code (9946). Using this code we can reset the user and the technical codes to
their default values.
6. PROGRAMMING
Insert the technical code (default=1111) and press the ENTER key. The Display
shows the indication PRO and the Program indicator led blinks. Now the system is
ready to be programmed.
6.1. PRO. Programming names of zones - rooms.
Insert the technical code (1111). The Display shows the indication PRO.
Press the ENTER key and the Display will show the indication P1 (this means that
the number which we will insert to the memory will correspond to terminal block 1).
Press the ENTER key again and the indication 1 appears (this is the preset name
which will appear on the Display every time that someone calls us from the zone
- room 1). If we want to change the name of the room we have to type the
number which we want to appear e.g. 101 and press the ENTER key to confirm
the process.
The Display shows the indication P 2 which is the next number of the memory
(second terminal block). Following the same process to name all the other memory
locations.
At the end of the process press successively the ESC key to exit programming mode.
6.2. SETUP. Adjusting the settings of the keyboard.
6.2.1. Address. Changing the address of the keyboard.
Insert the technical code (1111). The Display shows the indication PRO.
Press the key FAULT EVENTS until the Display shows the indication S-UP.
Then press the ENTER key again and the Display shows the indication Addr.
Press the ENTER key once more and the Display shows the indication _ _ _ 1 (this
means that this keyboard has address 1).
921746000_09_003
To Next Page
Loading...
