FLASH PHOTOGRAPHY WITH THE T32 (or T20) ELECTRONIC FLASH
Light Blue
If the lamp flickers: correct flash exposure
has been made.
If the lamp goes out: flash-to-subject dis-
tance is beyond the TTL AUTO working
range. Open up the lens stop or move in
closer to the subject.
If the lamp stays lighted: correct exposure
has been made by existing light, requiring
no flash.
In case exposure must be achieved by flash illumi-
nation, turn the aperture ring until the meter
needle points to 1/30 sec. or slower, and shoot.
NOTE: The OM-2 incorporates an incorrect flash
prevention system. If the shutter speed is faster
than the flash synchronizing range, the electronic
flash will not fire when you press the shutter re-
lease
button.
31
To Next Page
Loading...
