IFocusing on the subject
There are several ways to focus, depending on the subject.
When the subject
is
not
in
the center
of
the frame
• Place the subject
in
the center
of
the frame, lock the focus on the subject, and then recompose your
picture.
~
"Shutter button Shooting pictures/movies" (P. 11)
• Set [AF MODE] to [iESP].
~
"AF MODE Changing the focusing area"
(P.
24)
The subject is moving quickly
• Focus the camera on a point roughly the same distance away as the subject you want to shoot (by
pressing the shutter button halfway); and then recompose your picture and wait for the subject to
enter the frame.
Subjects that are difficult to focus on
• Under certain types
of
conditions, it is difficult to focus using auto focus.
Subject with low contrast Subjectwith an extremely
bright area in the center
of
the frame
Subject without vertical
lines
In
these
cases,
focus
(focus
lock)
on
an
object
with
high
contrast
at
the
same
distance
as
the
intended
subject,
recompose
your
shot
and
then
take
the
picture.
If
the
subject
has
no
vertical
lines, hold
the
camera
vertically
and
focus
the
camera
using
the
focus
lock
function
by
pressing
the
shutter
button
halfway,
and
then
return
the
camera
to
the
horizontal
position
while
keeping
the
button
pressed
halfway
and
take
the
picture.
:~
--
o
';1\
::J
o
:E
'<
o
C
"'"'I
("')
Q)
3
CD
Q3
0-
CD
~
CD
"'"'I
The subject
is
not in
the center
of
the frame
Fast-moving subjectSubjects at different
distances
!T'aking 'pictures without blurring
f
Hold the camera correctly and press the shutter button gently
to
shoot the picture.
In
addition, blurring is
reduced when taking pictures
in
the
(~))
mode.
The factors that can cause the picture to blur are as follows:
• When you zoom at a high magnification to shoot the picture
• When the shutter speed is set low to shoot a dark subject
• When the flash cannot be used or a low shutter speed set shooting mode is selected.
Most blurry images can be stabilized later.
~
"PERFECT FIX Editing pictures"
(P.
25)
fT'aking pictures without the flash
The flash fires automatically when insufficient light is available and may cause your image to be blurry.
When taking Rictures
in
low light without the flash, set the flash mode to
[@]
(flash off).
~
"I>
~
button Flash shooting" (P. 15)
Select a higher value for [ISO]
~
"ISO Changing the ISO sensitivity"
(P.
23)
EN
43
To Next Page
Loading...
