EasyManua.ls Logo

Olympus CAMEDIA C-5000 Zoom - User Manual

Olympus CAMEDIA C-5000 Zoom
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
QuickStart Guide
C-5000Zoom
PREPARING THE CAMERA FOR USE
Before you begin using your Olympus Digital camera…
a. Charging the battery
The battery is not fully charged when purchased. Before use, be
sure to charge the battery with the specified provided charger (LI-
10C).
Make sure that the + and - terminals of the battery shown in the
illustration on the right are correctly oriented when loading the
battery into the charger.
b. Inserting the battery xD-Picture card
c. Attaching the strap and lens cap string (OPTIONAL)
Attach the lens cap string and strap to the strap eyelets on each side of the camera as
illustrated. Attaching the strap to the camera makes it easier to handle.
1) Make sure the camera is turned off. 2) Slide the battery/card cover in the direction of
A, then lift in the direction of B.
B
A
3) Insert the battery, making sure it is correctly
orientated. Then use the battery lock to lock
the battery in place.
To remove the battery, slide the battery lock in the
direction of the arrow. As the battery emerges,
hold it straight and pull it out completely
.
4) Face the card the correct way and insert it into
the card slot.
To remove the card, push the card all the
way in to unlock it. As it emerges, hold the
card straight and pull it out.
5) Close the battery/card cover in direction C
then slide it in direction D.
Battery lock
Index area side
Groove section
TURNING ON THE CAMERA
The camera Mode dial is used to select the various operation modes.
a. Turning the camera ON (SHOOTING MODE)
Remove the lens cap.
Set the mode dial to h. Turn the power switch to the ON position. The lens extends and the monitor turns on.
To turn the camera off, turn the power switch to the OFF position.
:To maximize battery life, the Digital camera features a power saving mode in which the camera enters a sleep mode after
approximately three (3) minutes of non-use.
b. Setting the Date and Time (OPTIONAL)
Set the date and time before using the camera for the first time. This affects the way image file names are
created, and will conveniently include this information with each picture.
Set the mode dial to P and turn the power switch to the ON position.
•Press e. The top menu is displayed.
•Press d on the arrow pad to select MODE MENU.
•Press ac to select the SETUP tab, then press d.
•Press ac to select X, then press d.
•Use ac to select the date format.
Adjust the date and time in the appropriate fields by using d to select the field, and ac to set the proper value.
Repeat this step until all date/time fields have been set.
Note: Time is entered using the 24-hour format.
•Press e twice to set the date and time and exit the menu.
c. Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Mode dial
Power Switch
Power Switch
TIP
DC-IN jack
Self-timer/Remote control lamp
Flash
Lens
Zoom lever
Shutter
button
Strap eyelet
Remote control receiver
VIDEO OUT jack
USB connector
VT575301 1AG6P1P1559-- Printed in Japan
UNPACKING THE BOX CONTENTS
Gather your Digital camera and the parts as shown in the illustration. You’ll need these to complete the steps for the camera
set-up procedures that follow.
START HERE
It is strongly recommended that you follow these step-by-step
numbered instructions to set up and quickly begin using your
new Digital camera.
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville,
NY 11747-3157, U.S.A.
http://support.olympusamerica.com/
For more detailed instructions on advanced features, please refer to
the printed Basic Manual included in your package, or the Reference
Manual on the CD-ROM.
Camera Settings in Shooting Mode as shown in Monitor
Camera Settings in Playback Mode as shown in Monitor
Note: Depending on the camera settings, not all indicators will be displayed.
Viewfinder
Orange lamp
Mode dial
Erase button
Flash mode button
AEL/Custom button
Rotation button
Monitor
Arrow pad
OK/Menu button
Battery/Card cover
Tripod socket
Card access lamp
Macro/Spot button
Protect button
Green lamp
Hot shoe
Battery check
Green lamp
Flash stand-by
Flash mode
Macro mode
Memory gauge
Shooting modes
Self-timer/Remote Control
White balance compensation
ISO
Record mode
Number of storable
still pictures
AF target mark
Drive
Resolution
Shutter speed
Aperture value
Exposure compensation
Exposure differential
Noise reduction
Flash intensity control
AE lock
AE memory
Spot metering
White balance
Saturation
Sharpness
Contrast
Print reservation,
Number of prints
Resolution
Battery check
Shutter speed
Exposure compensation
White balance
ISO
Date and time
File number, Frame number
Playing time/total recording time
Record mode
Protect
Aperture value
OLYMPUS CO. (EUROPA) GMBH.
Wendenstrasse 14-18,
20097 Hamburg, Germany
http://www.olympus-europa.com/
The following items are also included in the Digital camera package: Basic Manual, video cable, RM-2 remote control, battery charger (LI-
10C), warranty card, registration card (not provided in some areas), and safety precautions booklet.
Digital camera Strap Lens cap & string Lithium ion battery CAMEDIA Master
CD-ROM
USB cable
(gray color)
xD-Picture Card
http://www.olympus.com/
C
D
x193_qsge_pquick_6.fm Page 1 Wednesday, July 9, 2003 9:09 PM

Other manuals for Olympus CAMEDIA C-5000 Zoom

Questions and Answers

  • R
    Ryan LeonardAug 17, 2025
    Why is my Olympus CAMEDIA C-5000 Zoom Digital Camera not turning on?
    • C
      Clinton McdonaldAug 18, 2025
      Your Olympus Digital Camera might not be turning on because the power is off, so ensure it is switched on. Also, the battery could be exhausted and needs charging. If it is cold, try warming the battery in your pocket. The camera might be in sleep mode; try pressing the shutter button or zoom lever. Finally, the camera will not operate while connected to a PC.
  • C
    Collin LeeAug 20, 2025
    Why can't I erase a picture on my Olympus CAMEDIA C-5000 Zoom Digital Camera?
    • S
      Sherri DavisAug 20, 2025
      If the picture is not erased on your Olympus Digital Camera, it might be protected. Pictures with the 0 mark cannot be erased; press the 0 button to cancel the protection.
  • K
    Katrina AdamsAug 22, 2025
    What to do if my Olympus Digital Camera won't take a picture?
    • R
      richard62Aug 22, 2025
      If your Olympus Digital Camera isn't taking pictures when you press the shutter button, the battery might be exhausted and needs charging. Ensure the camera isn't in playback mode (set the mode dial to any position except q). The flash may not have finished charging; wait until the flash standby indication stops blinking. The card might be full, so erase unwanted pictures or insert a new card. The battery may have run out of power during shooting; charge the battery and wait until the card access lamp turns off. The memory gauge could be full, so wait until there is room.
  • C
    Christopher HartAug 25, 2025
    Why are my Olympus CAMEDIA C-5000 Zoom pictures too dark?
    • T
      Theresa SuarezAug 26, 2025
      If your Olympus Digital Camera pictures are too dark, make sure your finger isn't blocking the flash. Ensure the subject is within the flash's working range. If the subject is small and backlit, set the flash to fill-in mode or use spot metering.
  • S
    Scott HesterAug 27, 2025
    Why are my Olympus CAMEDIA C-5000 Zoom photos too bright?
    • J
      Jon DuncanAug 28, 2025
      If your Olympus Digital Camera pictures are too bright, the flash might be set to fill-in mode; select a different flash mode. If the center of the subject is too dark, adjust the exposure compensation towards minus. A high ISO setting can also cause this, so set the ISO to AUTO or a low sensitivity of 50. In A (M) mode, increase the aperture value or switch to P mode. If in S (M) mode, increase the shutter speed or switch to P mode.
  • Z
    Zachary PearsonAug 30, 2025
    Why are my Olympus CAMEDIA C-5000 Zoom pictures out of focus?
    • D
      denisesnyderAug 30, 2025
      If your Olympus Digital Camera pictures are not in focus, try using manual focus or focus lock. Ensure you hold the camera correctly and gently press the shutter button. If the flash was off in low light, use a tripod or set the flash to AUTO. Also, clean the lens with a blower brush and lens cleaner.
  • G
    gallegossarahSep 1, 2025
    How to fix a hard to see Olympus CAMEDIA C-5000 Zoom monitor?
    • R
      Randy HoganSep 2, 2025
      If the monitor on your Olympus Digital Camera is hard to see, adjust the brightness in the mode menu by selecting 's'. If the monitor is exposed to direct sunlight, block the sunlight with your hand or use the viewfinder.
  • K
    Kenneth SmithSep 4, 2025
    How to stop my Olympus Digital Camera from resetting?
    • A
      albert66Sep 4, 2025
      If your Olympus Digital Camera settings revert to factory defaults when turned off, check if 'ALL RESET' is set to 'ON' in the SETUP tab of the mode menu and set it to 'OFF'.
  • R
    Ryan OwensSep 6, 2025
    Why doesn't the flash fire on my Olympus CAMEDIA C-5000 Zoom Digital Camera?
    • M
      Mr. Robert Martin IIISep 6, 2025
      If the flash on your Olympus Digital Camera doesn't fire, check if it's set to flash off mode and select a different mode. If the subject is brightly lit, set the flash to fill-in mode. Note that the flash does not fire in auto bracketing, movie, super macro, or panorama modes. Also, charge the battery if the remaining power is not indicated correctly.
  • S
    Samantha WilsonSep 9, 2025
    Why is the date wrong on my Olympus Digital Camera pictures?
    • M
      Matthew SantosSep 9, 2025
      If the date recorded in your Olympus Digital Camera image file is wrong, the date/time may not be set (the clock adjustment is not factory-preset). If the camera has been left without the battery for several days, the date/time setting is canceled; set it again.

Summary

Unpacking the Box Contents

Preparing the Camera for Use

Charging the Battery

Instructions for charging the battery using the provided charger.

Inserting the Battery and xD-Picture Card

Steps for inserting the battery and xD-Picture card into the camera.

Attaching the Strap and Lens Cap String

How to attach the camera strap and lens cap string for easier handling.

Turning On the Camera

Turning the Camera ON (Shooting Mode)

How to turn on the camera and enter shooting mode.

Setting the Date and Time

Procedure for setting the date and time on the camera.

Camera Diagram and Controls

Identifies key camera controls and their functions.

Taking Pictures

Taking a Picture

Step-by-step guide to composing and capturing a photo.

Zooming

How to use the zoom lens to adjust framing for shots.

Flash Modes

Explanation of different flash modes and their uses.

Number of Storable Pictures

Information on storage capacity related to image quality and card size.

Viewing and Erasing Pictures

Viewing Pictures

How to navigate and view stored images on the camera.

Erasing Pictures

Methods for deleting unwanted photos from the memory card.

Connecting the Camera to a Computer

Installing the Camera Software

Olympus CAMEDIA C-5000 Zoom Specifications

General IconGeneral
Effective Pixels5.0 million
Image Resolution2560 x 1920
Optical zoom3x
Digital zoom4x
Aperture Rangef/2.8 - f/4.9
ISO SensitivityAuto, 80, 100, 200, 400
DisplayLCD
LCD Screen Resolution134, 000 pixels
Storage MediaxD-Picture Card
Camera typeCompact
Image Sensor1/1.8 inch CCD
LensOlympus lens
Focal Length7.8 - 23.4mm (38 - 114mm equivalent in 35mm format)
ISO Range80, 400
LCD Screen Size1.8 inches

Related product manuals