216
TROUBLESHOOTING
OPERATING PROBLEMS
The camera does not work.
1 The power is OFF.
[ Set the Mode dial to turn on the power. (P. 30)
2 The batteries are loaded incorrectly.
[ Reload the batteries correctly. (P. 22)
3 The batteries are exhausted.
[ Replace the batteries with new ones. (P. 22)
4 The batteries are temporarily unable to function.
[ Keep the batteries warm while using the camera.
5 Power has shut off to conserve battery consumption.
[ Operate the shutter button or the zoom lever.
6 It is connected to a personal computer.
[ The camera will not operate while it is connected to a personal
computer.
No picture is taken when the Shutter release button is pressed.
1 The flash has not finished charging or the previous picture is being
written into the card.
[ Remove your finger from the Shutter release button and wait until
the Green lamp or the Orange lamp stops blinking. (P. 42/58)
2 There is a problem with the card.
[ See the Error code chart. (P. 221)
3 The card is full.
[ Replace the card, delete unwanted pictures or transfer the data to
a computer and delete all of the pictures. (P. 26/107/114/174 ~ 178)
4 The batteries ran out.
[ Replace the batteries with new ones. (P. 22)
5 The battery power is low.
[ Replace the batteries with new ones. (Do not open the Battery
compartment cover when the Card access lamp is blinking.)
(P. 22)
6 The buffer memory is full.
[ Wait until there is room in the buffer. (P. 45/123)
7 A write-protect adhesive seal is placed on the card or there is no card
in the camera.
[ Insert a new card in the camera. (P. 26)
8 The Mode dial is set to .
[ Set the Mode dial to P, A/S/M or . (P. 31)
To Next Page
Loading...
