69
Press the left arrow on the
Jog dial to confirm the setting.
If you take a picture without
pressing the OK button, the
setting will be valid until the
Menu is canceled.
• Press the OK button to save
the setting and cancel the
Menu.
• Sequential shooting is possible
up to 5 frames.
6
5
5 6
Note:
• The main flash cannot be used in the Sequence mode.
• When using an extension flash, set the speed fast enough to follow the
sequential shooting.
• Since the LCD monitor’s picture blacks out while taking pictures in the
Sequence mode, use the viewfinder to take pictures in this mode.
• Unless OFF is selected in All Reset, the setting will be canceled when the
power is turned off. (p. 188)
• This mode cannot be used in the TIFF recording mode.
• Since the slowest shutter speed in the Sequence mode is set to 1/30
second to prevent camera movement, the resulting picture may be darker
than expected.
• Sequential shooting will continue for as long as the Shutter release button
is held down. When the Shutter release button is released, Sequential
shooting stops.
• Even if the Sequence mode is switched to another mode after taking
sequential pictures, it will not be possible to take another picture until
recording in the card finishes.
• The speed will be slower with AF .
To Next Page
Loading...
