17
Insert the card fully with the contact area
facing towards the monitor side. Insert
until you feel it locked into place.
● Note the orientation of the card. If it is
inserted incorrectly, it may become
jammed.
Push in the card lightly to unlock it, then
pull it out.
Make sure the camera is turned off (i.e. the mode
dial is set to OFF).
Close the cover tightly.
1
2
3
3
4
Inserting the card
Ejecting the card
Inserting/ejecting the card
Be sure to use a 3V (3.3 V) card. Non-Olympus 3 V (3.3 V) cards must be
formatted with the camera. Do not use a 5 V card or a 2 MB card.
1 C-4040ZBasic-E2 01.6.25 11:16 AM Page 17
To Next Page
Loading...
