74
5
Notes on Recording For Voice Recognition
When recording voice to be processed
with voice recognition, set up your
DSS recorder as follows to improve
recognition accuracy.
• Set the microphone sensitivity to “DICT”
(☞ P.22).
• Set the recording mode to “SP” (☞ P.23).
• Set the Variable Control Voice Actuator
(VCVA) to “OFF” (☞ P.24).
• Register/enroll your voice in the voice
recognition software using the recorder.
• Record in a relatively quiet environment.
• Have the recorder microphone 5 to 10
cm (2 to 4 inches) away from your chin.
The file recorded in the next condition,
will be a low rate of recognition, which
can not be used for voice recognition.
• A conference or meeting where many
voices are recorded.
• Seminar or lecture where high-level
ambient noise tends to be recorded.
• Speak normally.
• It is recommended to use the noise-
cancellation microphone ME12, when
recording.
Using Voice Recognition Software
Using Voice Recognition Software
To Next Page
Loading...
