Flash shooting
43
3
Basic shooting functions
1 Press d#.
• The flash mode settings screen is displayed.
g“How to use the direct buttons” (P. 13)
2 Select a flash mode, and press Z.
3 Press the shutter button halfway.
• In conditions where the flash will fire, #
lights (flash stand-by).
4 Press the shutter button fully to
take the picture.
TIPS
The # (flash charge) mark blinks.
→ The flash is charging. Wait until # turns off.
Note
• The flash does not fire in the following situations:
Sequential shooting, super macro or panorama.
• The flash may not give you the optimum result in macro mode with the zoom
set to wide-angle (W). Check the resulting picture on the monitor.
FLASH MODE
SELECT
GO
OK
The flash fires automatically
in low light.
AUTO
HQ
To Next Page
Loading...
