26 27
CUSTOM SETUP
Custom setup allows each user to customize flash setup to suit his or her preferences.
Setup procedure
1. Turn the electronic flash on.
2. Press and hold the MODE button for more than 2 sec-
onds, until the setup mode display appears in the control
panel.
3. Turn dial A to select the setup mode.
4. Turn dial B to select the value.
5. Press the MODE button to exit from setup and return to
the previous control panel display.
●Power grip
• Flash Power Grip FP-1 (To be used in combination with the RG-1 remote grip cable)
OPTIONAL ACCESSORIES
This accessory allows the electronic flash to be used as a
grip-on type flash powered from four C (R14) alkaline dry cell
batteries.
Using these batteries together with the electronic flash bat-
teries makes it possible to charge the flash at a higher speed
and increase the available flash emission count.
●External power supply
• Flash High Voltage Set SHV-1
(High Voltage Pack HV-1, Ni-MH Battery Pack BN-1, and AC Adapter AC-2)
The BN-1 Ni-MH battery pack incorporated in this accessory
makes it possible to charge the flash at a higher speed and
increase the available flash emission count.
Batteries
* The flash emission interval and count data were obtained from in-house tests at Olympus.
* The flash emission interval data represents the performance of fresh batteries. The figures increase as the
batteries are depleted.
* The flash emission interval data refers to the values obtained with MANUAL flashing at a 1/1 light intensity ratio.
The figure decreases when the light intensity is lower.
Flash emission
interval
Flash emission
count
FP-1 (C/R14 alkaline batteries) FL-50 (Alkaline batteries) Approx. ● sec. ≥ ●● times
FP-1 (C/R14 Ni-Cd batteries) FL-50 (CR-V3 battery packs)
FP-1 (C/R14 alkaline batteries) FL-50 (No battery)
HV-1 (Ni-MH battery pack BN-1) FL-50 (Alkaline batteries)
HV-1 (Ni-MH battery pack BN-1) FL-50 (CR-V3 battery packs)
HV-1 (Ni-MH battery pack BN-1) FL-50 (No battery)
4-3
m
on
A
on
OFF
Setup mode
Mode display Value display
Function Default
Dial A Dial B
AF illuminator AF illuminator is activated according to the
control from the camera.
AF illuminator is defeated.
Flash cable
Use this setting when using the flash
cable.
Use this setting when not using the flash
cable.
Firing angle
(ZOOM) display
Firing angle (ZOOM) is displayed in terms
of the lens focal distance of a FOUR
THIRDS digital camera.
Firing angle (ZOOM) is converted into the fo-
cal distance of a 135 camera.
This allows the flash to be used in the same
feeling as the flash for a 135 type film camera.
Distance display
unit
Distance is displayed in meters.
Distance is displayed in feet.
Light intensity
adjustment
Light intensity cannot be adjusted.
Light intensity can be adjusted.
Wide panel
switch disabling
Wide panel switch is defeated when the
wide panel malfunctions.
Wide panel switch is not defeated when
the wide panel malfunctions.
To Next Page
Loading...
