Olympus FL-900R - Choosing a Flash Control Mode

26
EN
4
Press the shutter button the rest
of
the
way
down
to take the picture.
•
The
AUTO CHECK lamp blinks
for about 5 s after shooting to indicate that
the flash has fired successfully.
• When using a flash, flash light may
be
blocked
by the lens
body, lens
hood, etc.
•
The flash may become hot when fired many times
in
succession,
resulting
in
damage or
malfunction.
The flash
should
be fired no more than
50
times
in
succession at
intervals
of 2.5 seconds, after which it
should be
left
unused for
at
least 1
0 minutes.
Test
Flash
To
fire a test flash, press the
TEST button
while the CHARGE
lamp
is lit.
The
AUTO CHECK lamp blinks
for about
5 s to indicate that the flash has fired
successfully. If
the
lamp
does not
blink, adjust settings or change the distance to
the subject.
Choosing a Flash Control
Mode
Choose a flash
control mode according to your subject and shooting conditions.
1
Press the
MODE
button.
•
Settings
will
be displayed.
2 Rotate the
dial
to
choose
a flash
control
mode.
r:r:~r-l
Value
ffim
Set
003
•
The flash
control mode can also
be
selected
by pressing the
MODE
button.
• Related
settings (if
displayed) can
be
highlighted by pressing
<ll>
and
changed by rotating the dial.
3
Press the
OK
button to put the changes into effect.
• I
••
TTL-AUTO
TTL!
0.0
ILWj2Smm
l1l'.i.'mffil
0.7
-8.0m
.I:L
A
OFF
The flash
light intensity is
controlled
automatically
according to the camera's
setup. The flash will
be adjusted based on
the brightness taken through the camera's
lens. Usually
use this mode with a camera
with communication
capability.