OmniScan MX2 — Getting Started Guide 3
Warnings on Battery Use
Carefully read and observe the following warnings on battery use.
• Do not open, crush, or perforate batteries; doing so could cause injury.
• Do not incinerate batteries. Keep batteries away from fire and other sources of extreme heat.
Exposing batteries to extreme heat (over 80 °C) could result in an explosion or personal
injury.
• Do not drop, hit, or otherwise abuse a battery, as doing so could expose the cell contents,
which are corrosive and explosive.
• Do not short-circuit the battery terminals. A short circuit could cause injury and severe
damage to a battery, making it unusable.
• Do not expose a battery to moisture or rain; doing so could cause an electric shock.
• Only use the OmniScan MX2 or an external charger approved by Olympus to charge the
battery.
• Do not recharge a battery unless the indicators light up when the capacity check button on
the battery is pressed. Doing so could be dangerous.
• Do not store batteries that have less than 40 % remaining charge. Recharge batteries to
between 40 % and 80 % capacity before storing them.
• During storage, keep the battery charged to between 40 % and 80 %.
• Do not leave the battery in the OmniScan MX2 during instrument storage.
Replacing a Lithium-Ion Battery
To replace a lithium-ion battery
1. On the right side panel, turn the two quarter-turn latches counterclockwise to open the battery
compartment door.
2. Remove the battery by pulling on the strap.
3. Insert a new battery. Make sure that the groove on the battery is aligned with the small edge inside
the battery compartment.
4. Close the battery compartment door.
Battery compartment door
Lithium-ion battery (P/N:
OMNI-A-BATT
[U8760010])
To Next Page
Loading...
