EN 18
EN
Install the O-ring
Confirm that no foreign matter is in the groove and then fit the O-ring. At
this time, confirm that the O-ring does not stick out from the groove.
When sealing this product, make sure that no hairs, fibers, sand particles
or other foreign matter stick not only to the O-ring, but also to the contact
surface (front lid). Even a single hair or a single grain of sand may cause
water leakage. Please check with special care.
PT-057_EN.book Page 18 Friday, November 21, 2014 10:13 AM
To Next Page
Loading...
