SOLTIVE™ Premium / Pro Quick Reference Guide 7
Pair the wireless footswitch
n Place the wireless footswitch near the device.
n To begin pairing from the Home screen enter System Setup via the
Settings screen. Note the footswitch icon indicated with a crossed line
when not paired. To pair the footswitch to the laser system, place the
footswitch in the vertical position. Tap Continue when ready.
n Press the button on the back of the footswitch for 3-6 seconds and then
tap Continue. Successful pairing will be indicated on the screen.
n Alternatively, if using the wired footswitch,
connect the cable in the rear of the laser
system into the footswitch connector port,
circled in the figure to the right. Pairing is
not needed with the wired footswitch.
Laser Operation
To Next Page
Loading...
