14
En
1 Press 2Y.
2
Press
12
to select [12s] or [2s], and press
o
.
3 Press the shutter button completely to take
the picture.
12s The self-timer lamp lights for approximately
10 seconds, then starts blinking. After
blinking for approximately 2 seconds, the
picture is taken.
2s The self-timer lamp blinks for 2 seconds, then
the picture is taken.
1 Press#UP in shooting mode to open the flash.
2 Press 3#. Press 43 to select the flash mode, and press o.
3 Press the shutter button halfway.
When the flash is set to fire, the # mark lights.
4 Press the shutter button completely to take the picture.
To save battery power, the camera automatically enters sleep mode and
stops operating if not used for a certain amount of time in shooting mode.
Press the shutter button or other buttons to reactivate the camera.
If the camera is not operated for a further 12 minutes after the camera
enters sleep mode, it automatically retracts the lens and turns off. To
resume operation, return the power switch to OFF and then set the
power switch to ON.
Icon Flash Mode Description
AUTO Auto flash
The flash fires automatically in low light or
backlight condition.
!
Red-eye reduction
flash
Emits pre-flashes for red-eye reduction.
# Fill-in flash
The flash fires regardless of the available light.
H Red-eye fill-in flash
The flash always fires after pre-flashes for
red-eye reduction are emitted.
#SLOW
Slow synchronization
The flash fires right after the shutter fully
opens (1st curtain).
!SLOW
Slow synchronization/
Red-eye reduction
flash
While using slow synchronization (1st curtain)
with flash shooting, you can also use this
function to achieve red-eye reduction.
#SLOW2
Slow synchronization
2
The flash fires just before the shutter closes
(2nd curtain).
$ Flash off The flash does not fire.
Self-Timer
Self-Timer Lamp
Flash Modes
Power Save Feature
d4364_e_basic_00_bookfile.book Page 14 Friday, December 21, 2007 6:46 PM
To Next Page
Loading...
