37
EN
Using an Eye-Fi card
d
[Eye-Fi]
Submenu 2 Application
All Transfers all images.
Sel. Image Transfers only selected image.
Off Disable Eye-Fi communication.
When using an Eye-Fi card, read the Eye-Fi card
instruction manual carefully, and comply with the
instructions.
Use the Eye-Fi card in compliance with the laws and
regulations of the country where the camera is used.
In locations such as on an airplane, where the Eye-Fi
communication is prohibited, remove the Eye-Fi card
from the camera, or set [Eye-Fi] to [Off].
This camera does not support the Eye-Fi card’s
Endless mode.
Selecting a method for connecting the
Selecting a method for connecting the
camera to other devices
d
[USB Connection]
Submenu 2 Application
Auto
Set to select the connection method
each time the camera is connected
to another device.
Storage
Connect camera as a card reader.
MTP
For Windows Vista or Windows 7,
connect camera as a portable device.
Print
Select when connecting to a
PictBridge-compatible printer.
When using the attached software, select [Storage].
Refer to “Connecting with a computer” (p. 43) for the
connection method with a computer.
Turning on the camera with the
Turning on the camera with the
q
button
d
[
q
Power On]
Submenu 2 Application
No
The camera is not turned on. To turn
on the camera, press the n
button.
Yes
Press and hold the q button to turn
the camera on in the playback mode.
Selecting the camera sound and its
Selecting the camera sound and its
volume
d
[Sound Settings]
Submenu 2 Submenu 3 Application
Sound Type
1/2/3
Selects the camera sounds
(operation sounds and
shutter sound).
Volume
0/1/2/3/4/5
Select button response tone
level and power on sound
level.
q Volume
0/1/2/3/4/5
Selects the image playback
volume.
To Next Page
Loading...
