5
6 Mounting the Eyepiece
(Fig. 9)
1. Remove the eyepiece dust caps @ and loosen the eyepiece clamping
screws ² completely.
2. Gently insert the cross-lined eyepiece (CROSS WHS10X) ³ (if this is not
provided, use the WHS10X-H) into the right eyepiece sleeve until it stops.
3. Gently insert the eyepiece (WHS10X-H) into the left eyepiece sleeve until
it comes up against the stop.
4. Tighten both eyepiece clamping screws ².
7 Mounting (Removing) the Stage Plate
(Fig. 10)
Place the stage plate (white, black on back side) into the mounting hole
on the base.
To remove, press the stage plate at the edge nearest to the pillar with
your fingertip. The opposite end will rise from the base so the stage plate
can be picked up easily.
8 Mounting the Specimen Holder
(Fig. 11)
Insert the specimen holder @ into the 2 holes ² on the top surface of the
base.
9 Positioning the Microscope Body on the Stand
(Fig. 12)
Loosen the focusing assembly clamping knob @. Slightly pivoting the
microscope body to the left and right, align the center of the objective
with the center of the stage plate ², then clamp the microscope body
with the focusing assembly clamping knob.
Fig. 9
Fig. 10
Fig. 11
Fig. 12
@
²
³
@
²
@
²
To Next Page
Loading...
